Cary-audio-design A 306 User Manual download pdf (Page 9)

Specifications

_________________________________________

Operating the A 306 Power amplifier is a simple procedure, since each unit is designed for long

term stability in virtually any home operating situation. However, if the unit is operated outside

the parameters outlined in this owner’s manual, damage may result. Please read this manual

carefully before putting your new Cary Audio Design A 306 in operation. The following

definitions are applicable to this manual. Please follow these definitions carefully.

1.1 Specifications

The following section describes the A 306 Power amplifier basic specifications. Specifications

are subject to change without notice or obligation.

Rated power output: 600 Watts per channel rms. at 8 Ω

1,100 Watts per channel rms. at 4 Ω

Rated total harmonic

distortion: 0.2 % THD

Frequency response:

+ 0.5 dB from 20 Hz to 20 kHz

Controller Connectors: 1 - IEC AC mains receptacle

4 - custom binding posts

1 - 3.5 mm “mini plug” jack for remote ‘trigger’ in

1 pair 3-pin XLR balanced input connector

1 pair RCA input connector

Signal-to-Noise ratio: -80 dB CCIR

Input impedance: 100 k Ω (RCA unbalanced)

200 k Ω (XLR balanced)

Voltage gain: 27.2 dB

Input sensitivity: 0.7 V (full-rated output)

Damping Factor: > 1,000, 20-20,000 Hz

Power Input: Configured at factory for either

100-120 or 200-240 VAC, 50-60 Hz

Power Consumption: 100 Watts at idle; 15 Watts in standby,

1,200 Watts at full power

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Cary-audio-design A 306 User Manual Page 9